Removing and installing or replacing rear carpet on seat pan (4' Series Convertible)
Necessary preliminary tasks:
- Clamp off BATTERY LEAD FROM NEGATIVE CONNECTION POINT .
- Remove both front seats. Refer to REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE (4' SERIES COUPE) , or REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE (NORMAL/MANUAL) (4' SERIES GRAN COUPE SEDAN) , or REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT, DRIVER'S SIDE, (NORMAL/ELECTRIC) (4' SERIES GRAN COUPE SEDAN) , or REMOVING AND INSTALLING FRONT SEAT, DRIVER'S SIDE (NORMAL/ELECTRIC) (4' SERIES CONVERTIBLE) , or REMOVING AND INSTALLING FRONT SEAT, PASSENGER'S SIDE (4' SERIES COUPE) , or REMOVING AND INSTALLING FRONT SEAT (NORMAL/ELECTRIC) ON THE PASSENGER'S SIDE FROM LEFT OR RIGHT (4' SERIES GRAN COUPE SEDAN) or REMOVING AND INSTALLING FRONT PASSENGER SEAT (NORMAL/ELECTRIC) (4' SERIES CONVERTIBLE) or REMOVING AND INSTALLING THE FRONT SEAT ON THE PASSENGER'S SIDE (NORMAL/MANUAL) (4' SERIES GRAN COUPE SEDAN) .
- Remove BOTH SIDE TRIM PANELS , rear
- Remove COMPLETE CENTER CONSOLE .
- Remove central bass speaker trim on left/right. Refer to REMOVING AND INSTALLING/REPLACING CENTRAL BASS SPEAKER - DRIVER'S SIDE- (UNDER FRONT SEAT) (4' SERIES COUPE/CONVERTIBLE) , or REMOVE AND INSTALL/REPLACE THE CENTRAL BASS ON THE PASSENGER'S SIDE (UNDER THE FRONT SEAT) (4' SERIES COUPE/CONVERTIBLE, 4' SERIES GRAN COUPE SEDAN)
Disconnect cable (1) from handbrake check switch.
Unclip cable clip (2) from parking brake lever.
Loosen nuts (3) on cable clip only.
Installation note:
Replace self-locking nuts.
Tightening torque 34 41 1AZ .
IMPORTANT:
Risk of damage!
Pay attention to cables when cutting.
Pay attention to cables when cutting.
Cut carpet (1) along line (2).
Feed carpet (1) out to the top from the parking brake lever (3).
Installation note:
Apertures (1) serve as alignment points when fitting carpet (2).
Replacement:
Lay removed carpet over new one and transfer cuts to new carpet.