Removing and installing left or right front seat, driver's side, (normal/electric) (4' Series Gran Coupe Sedan)
Necessary preliminary work:
- Disconnect BATTERY NEGATIVE CABLE
Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.
Installation note:
- Powerlok screws must be replaced and must not be reused
- Powerlok screws are mechanical screw locks with trilobular threads
For electrical front seat version:
Move backrest to full rearward position.
Grip end fitting cover centrally between seat belt strap and cover.
Unclip end fitting cover in direction of arrow.
Installation note:
Install end fitting cover as follows:
- Insert cover with rear guide in covering.
- Insert cover in direction of arrow downwards in covering
- Engage top left of cover in covering.
Release screw (1).
Tightening torque 72 11 02AZ .
Remove end fitting.
Installation note:
End fitting is coded against incorrect assembly.
Move seat to upper back position.
Release and dispose of screws (1).
Adjust the seat to the front top.
Release and dispose of screws (1).
Disconnect plug connection (1).
Lift out front seat.
Installation note:
- Carpet must not get between seat rails and floor panel in area of attachment points (creaking noises)
- Replace microencapsulated screws
- Insert all screws loose to avoid twisting
- Tighten down all screws to specified torque
Tightening torque 52 10 01AZ .
Incorrect handling may activate the pyrotechnical seat belt tensioner or side airbag and thereby cause injuries.