Removing and installing/replacing DSC control unit (4' Series Coupe/Convertible, 4' Series Gran Coupe Sedan)
IMPORTANT:
Read and comply with NOTES
on protection against damage from electrostatic discharge (ESD protection).
Necessary preliminary tasks:
- Remove HYDRAULIC UNIT .
IMPORTANT:
Risk of damage to the contacts when removing and installing the hydraulic unit.
Release screws (1) and carefully detach control unit (2) towards front.
Installation note:
Keep sealing surfaces clean.
Replace screws.
Observe tightening sequence (1-4).
Tightening torque 34 51 1AZ .
Replacement:
- Carry out PROGRAMMING/ENCODING
- Steering angle sensor adjustment
or
Adjustment for active steering
- Brake line mix-up test:
- Function check, hydraulic unit