11 66 000 Removing and installing/replacing vacuum pump: Notes

Preliminary work: 

• Refer to LOWER FRONT AXLE SUPPORT
• Refer to REMOVING FRONT AXLE DIFFERENTIAL
• Refer to REMOVING BEARING SUPPORT
• Refer to REMOVING THE OIL FILLER CAP
• Release the oil drain plug (when re-installing drain plug, tighten to: 25 Nm)
• Refer to REMOVING STARTER MOTOR
• Refer to REMOVING OIL SUMP 

Follow-up work: 

• Refer to REFITTING ENGINE OIL PAN 
• Tighten the oil drain plug to 25 Nm
• Refer to INSTALLING STARTER MOTOR
• Refer to INSTALLING BEARING SUPPORT
• Refer to INSTALLING FRONT AXLE DIFFERENTIAL
• Refer to RAISE FRONT AXLE SUPPORT
• Check engine oil level and top up oil as necessary