32 11 100 Replacing gaiter for steering box on left or right
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
Attention!
The hydraulic steering gear must be replaced if the polished surface of the rack is damaged (e.g. by corrosion)!
Necessary preliminary work:
- Remove the UNDERBODY PROTECTION
- Remove the COVER of front steering assemblies (diesel-engine cars with rear-wheel drive only)
- Remove the TRACK ROD END
Clean track rod.
Release the EAR CLAMP (1) and band clamp (2).
Detach gaiter from track rod.
Installation note:
Clean rack and check surface for damage (e.g. by corrosion).
Clean track rod and apply grease to taper.
NOTE:
This ensures that the gaiter is not rotated when the track rod is rotated.
After installation:
- Perform CHASSIS/WHEEL ALIGNMENT CHECK