32 00 155 Kinematics Diagnosis System wheel alignment with ride height measurement without loading the vehicle
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
Attention!
Do not perform wheel alignment with the vehicle unladen.
- If the technical prerequisites for alignment with ride height input are not fulfilled
- If the vehicle in question is a damaged vehicle
NOTE:
- Read and comply with GENERAL INFORMATION AND DEFINITIONS.
- Read and comply with GENERAL CHASSIS DEFINITION.
- Update the KDS DATA STATES
- Check compliance with TEST CONDITIONS , repair vehicle if necessary.
- If necessary, prepare vehicle hoist.
- Drive vehicle onto vehicle hoist.
NOTE:
The front and rear wheels must be positioned centrally on the rotary and sliding plates.
NOTE:
Rotary and sliding plates can vary from the graphic depending on the manufacturer!
NOTE:
Start up active steering prior to wheel alignment.
On vehicles with rear axle slip angle control: The service function "Moving HSR actuator to the center position" is included in the active steering start-up.
- Vehicles with active steering:
Start up active steering prior to wheel alignment.
On vehicles with rear axle slip angle control: The service function "Moving HSR actuator to the center position" is included in the active steering start-up.
- Attach pickup/ride height marks to vehicle (observe specifications from the various equipment manufacturers).
- Enter customer and vehicle data
- Identify equipment specification of the chassis and suspension and select vehicle
- Enter tire inflation pressure and tread depth
- Measure VEHICLE RIDE HEIGHT
with tape measure (only Beissbarth KDSII wheel alignment equipment)
If the ride height is outside the tolerance range (+40/-20 mm), load or unload the vehicle accordingly to adjust the vehicle in this ride-height window.
- Install the brake pedal tensioner.
- Remove locking pins from both rotating and sliding plates.
- Perform wheel alignment according to the instructions of the equipment manufacturer.
- If necessary, adjust TOE-IN ON FRONT AXLE , and REAR AXLE .
- Perform wheel alignment according to the instructions of the equipment manufacturer.
- Save and print out test record.
- Insert locking pins into both rotary and sliding plates.
- Remove pickup/ride height marks from vehicle (observe specifications from the various equipment manufacturers).