52 26 412 Replacing backrest cover for right rear seat

Special tools required: 

• 52 0 050

Necessary preliminary tasks: 

• Remove right BACKREST 
• Remove the GUIDE SLEEVES  right

Release screw (1).

Tightening torque, refer to: 52 26 03AZ.

Remove outer mount (2).

Installation note: 

Replace screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out welt in marked area from backrest frame.

Remove backrest cover with padding from backrest frame.

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and upholstery: 

• Release all clamps on trim wires.
• Remove cover from upholstery
• Remove remaining clamps from cover and upholstery

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Insert new clamp (2) with special tool 52 0 050 and bend closed.

1. Upholstery
2. Clamp
3. Trim wire in upholstery
4. Trim wire in backrest cover
5. Backrest cover

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover: 

• Remove all trim wires from cover
• If necessary, cut pockets in new cover for trim wires
• Push trim wires into cover pockets

Courtesy of BMW OF NORTH AMERICA, INC.