63 11 760 Replacing FLEL control unit

Attention!

Read and comply with notes on protection against electrostatic damage, refer to: (ESD PROTECTION ).

Necessary preliminary tasks:

Removal:

Release screws (1).

Remove Frontal Light Electronics control unit (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect the connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect and lock the connector (1).

Installation note:

Gasket (3) on control unit Frontal Light Electronics (2) should not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.

Install Frontal Light Electronics control unit (2).

Tighten down screws (1).

Tightening torque, refer to: 63 11 1AZ.

Courtesy of BMW OF NORTH AMERICA, INC.

Required reworking: