31 53 040 Removing and installing/replacing right output shaft bearing block

WARNING: This page does not describe the selected car, but rather 41 other vehicles, including the 2018 BMW 320i xDrive, 2018 BMW 320i, 2017 BMW 320i xDrive, 2017 BMW 320i, and 2016 BMW ActiveHybrid 3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

REMOVE right output shaft.
Release sound insulation of oil sump if necessary.

Release screws (1).

Tightening torque: 31 60 1AZ .

Remove bearing support from oil sump.

Installation note:

Replace O-RING .

Fig 1: Identifying Oil Sump Screws

Courtesy of BMW OF NORTH AMERICA, INC.