12 61 285 Removing and installing/replacing oil level sensor for engine oil (N55 hybrid)
IMPORTANT:
Read and comply with notes on protection against damage from electrostatic discharge (ESD protection).
WARNING:
High-voltage system - danger to life!
The following points must be strictly observed prior to starting work :
The following points must be strictly observed prior to starting work :
- Observe SAFETY INFORMATION for handling hybrid cars
Necessary preliminary work:
- Switch off ignition.
- Remove front UNDERBODY PROTECTION .
- Drain ENGINE OIL .
Unlock connector (1) and remove.
Unscrew nuts (2).
Tightening torque: 12 61 2AZ .
Remove oil level sensor (3).
Installation note:
Clean sealing surface on oil sump.
Replace seal on oil level sensor.
An excessively low torque value will result in oil leaks.
An excessively high torque value will result in damage to the oil level sensor.
Top up engine oil.
NOTE:
Check stored fault message.
Clear diagnostic fault entries from fault memory.
Clear diagnostic fault entries from fault memory.