11 61 360 Removing and installing/renewing pressure pipe from exhaust turbocharger to charge air cooler (N47D20 K/U/O/T 1)
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Necessary preliminary tasks:
- Remove intake filter housing . See 13 71 000 REMOVING AND INSTALLING/REPLACING INTAKE SILENCER HOUSING (N47 D16/20 K/U/O/T 1) or 13 71 000 REMOVING AND REFITTING/REPLACING INTAKE FILTER HOUSING (N47 D20 O 1 WITH SCR)
NOTE:
Snap lock (1) into place on lock (see arrow).
Release lock (1) in direction of arrow.
Release pressure pipe (2) in direction of arrow.
Release lock (1).
Release pressure pipe (2) in direction of arrow.
Check sealing lip (1) for damage.
Installation note:
If sealing lip (1) is damaged, the gasket must be replaced.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Check sealing ring for damage.
Installation note:
If sealing lip (1) is damaged, the gasket must be replaced.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Assemble engine.
Check differentiated air intake system for leak tightness.