41 61 000 Removing And Installing Hood/Bonnet
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
Read contents of BODY, GENERAL .
Necessary preliminary tasks:
- Disconnect all cable plug connections
WARNING:
Risk of injury!
Support engine hood in fully opened position with suitable apparatus.
Support engine hood in fully opened position with suitable apparatus.
IMPORTANT:
Removal of the hood/bonnet must be carried out with the assistance of a second person.
NOTE:
Carry over schematic representation to the relevant vehicle type.
Disconnect gas-pressure damper from engine hood/bonnet (1).
Release nuts (2) and (3).
Tightening torque 41 61 1AZ .
Remove hood lid.
Installation:
Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.
If this is not possible, ADJUST ENGINE HOOD .