41 5.... Removing And Installing Door

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Do not damage adjoining body parts.

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Release screw on connector frame.

Tightening torque 41 51 4AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Secure door against closing.

Release screw (1) on door retainer.

Tightening torque 51 21 3AZ .

Open door up to stop.

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts between both hinge elements at top and bottom.

Tightening torque 41 51 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Pull plug connection from door pillar, unlock by pulling out bar and detach.

Unhinge door by moving upwards and placing it on a suitable surface.

Installation:

If necessary, adjust DOOR .

Courtesy of BMW OF NORTH AMERICA, INC.