12 14 651 Replacing suction pressure sensor on charge air duct (N54)

Necessary preliminary tasks:

NOTE: The installation location of the suction pressure sensor is at the rear end of the charge air duct.

Unlock connector (1) and remove.

Release screws and pull suction pressure sensor (2) out of charge air duct.

Tightening torque 13 62 2AZ .

Fig 1: Identifying Charge Air Duct Suction Pressure Sensor And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check sealing ring for damage. Replace damaged sealing ring.

When installing, coat sealing ring with suitable lubricant.

Fig 2: Locating Charge Air Duct Suction Pressure Sensor Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Reassemble the vehicle.
Check stored fault messages.
Delete fault memory.