Replacing pulse sensor on intake camshaft (N55) (X6 xDrive 35i, X6 sDrive 35i)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove FAN COWL .
Unlock connector (1) and remove.
Release screw.
Tightening torque 13 62 3AZ .
Remove pulse sensor (2).
NOTE:
Check stored fault messages.
Clear diagnostic fault entries from fault memory.
Clear diagnostic fault entries from fault memory.