Removing and installing or replacing console for windscreen washer system complete with motor (X6 M)
Necessary preliminary tasks:
- Remove COWL PANEL COVER .
Release screws (1). Tightening torque 61 61 1AZ .
Disconnect plug connection (2).
Maneuver console for windscreen wiper system (3) out of guide (5).
Remove console for windscreen wiper system (3) upwards.
Installation note:
Rubber guide (4) must be correctly seated in guide (5).
Installation note:
Before installing wiper arms, allow wiper motor running in its rest position.
To ensure the wiper system works properly, CHECK THE CONTACT ANGLE OF THE WIPER ARMS and if necessary correct.