11 41 000 Removing and Installing/Replacing Oil Pump (N55) (up to production date March 2012)

Special Tools Required:

11 4 120 .
2 303 793 .

IMPORTANT: Aluminum Screws/Bolts Must Be Replaced Each Time They Are Released .
Aluminum Screws/Bolts Are Permitted with and Without Color Coding (Blue).
for Reliable Identification:
Aluminum Screws/Bolts Are Not Magnetic .
Joining Torque and Angle of Rotation Must Be Observed Without Fail (Risk of Damage) .

Necessary Preliminary Tasks:

Remove OIL SUMP .
Remove SEALING CAP of Vacuum Pump.

Undo All The Aluminum Screws (1) Along The Line.

Installation Note:

Replace Aluminum Screws.

Remove Intake Pipe with Oil Deflector.

Installation Note:

Replace O-Ring.

Fig 1: Removing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Press Timing Chain with Chain Tensioner (1) In Direction of Arrow.

Disconnect Timing Chain with Special Tool 11 4 120 .

Feed Out Camshaft Sprocket (3) At Hexagon Head (4) of Vacuum Pump.

Installation Note:

If The Chain Module Is Replaced, A Mounting Bar (2) Is Already Pre-Installed.

Fig 2: Pressing Timing Chain with Chain Tensioner

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Sprocket Must Be Blocked In Order To Release Central Bolt (1).

Secure Special Tool 2 303 793 To Crankcase.

Release Oil Pump Central Bolt (1).

Tightening torque 11 41 5AZ .

Fig 3: Releasing Oil Pump Central Bolt Using Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Release Aluminum Screws (1).

Tightening torque 11 41 6AZ .

Installation Note:

Replace Aluminum Screws.

Watch Mounting Flats On Oil Pump Sprocket.

Fig 4: Identifying Oil Pump Drive Gear and Aluminum Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Observe Different Screw Lengths.

Release Aluminum Screws (1).

Tightening torque 11 41 2AZ .

Installation Note:

Replace Aluminum Screws.

Fig 5: Identifying Aluminum Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Detach Sprocket (1) In Direction of Arrow.

NOTE: Chain Tensioner Presses Timing Chain (3) Upwards.
Do Not Remove Sprocket (1).

Remove Oil Pump (2) In Direction of Arrow.

Fig 6: Detaching Sprocket and Removing Oil Pump

Courtesy of BMW OF NORTH AMERICA, INC.

Installation Note:

Check Spacer Bushes for Secure Seating and Damage; Replace If Necessary.

Fig 7: Locating Spacer Bushes

Courtesy of BMW OF NORTH AMERICA, INC.

Install Oil Pump (2).

Align Mounting Flats (3) On Oil Pump (2) To Sprocket (4).

Fig 8: Identifying Oil Pump, Twin Surface, and Spacer Bushings

Courtesy of BMW OF NORTH AMERICA, INC.

Install Intake Pipe with Oil Deflector.

Installation Note:

Replace O-Ring.

Insert All The Aluminum Screws (1) Along The Line.

Installation Note:

Replace Aluminum Screws.

Tightening torque 11 41 1AZ .

Fig 9: Identifying Aluminum Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine.