11 14 010 Replacing Sealing Cap for Vacuum Pump (N55)

Special Tools Required:

Necessary Preliminary Tasks:

Removing Sealing Cap

Prepare Special Tool 11 8 530 .

Remove Special Tool 11 8 533 From Special Tool 11 8 532 .

Install Special Tool 11 8 534 .

Special Tool 11 8 536 Is Not Required.

Fig 1: Removing Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Attach Special Tool 11 8 531 To Long Special Tool 11 8 535 .

Short Special Tool 11 8 535 (Short); A 6 Mm Thick M10 Washer Must Be Placed Underneath Between Crankcase and Special Tool 11 8 531 .

NOTE: for Purposes of Clarity, Graphics Show Alternator and Power Steering Pump Removed.

Fig 2: Attaching Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Special Tool 11 8 537 Must Be Positioned Manually On Sealing Cap.

Screw In Special Tool 11 8 534 .

NOTE: The Sealing Cap Is Pressed Out Diagonally During This Operation

Fig 3: Positioning/Installing Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Installing Sealing Cap

Prepare Special Tool 11 8 530 .

Remove Special Tool 11 8 534 From Special Tool.

Install Special Tools 11 8 533 and 11 8 532 .

Fig 4: Removing Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Screw In New Sealing Cap (1) with Special Tools 11 8 532 and 11 8 533 Until Flush with Crankcase Upper Part.

Fig 5: Installing Sealing Cap Using Special Tools 11 8 532 and 11 8 533

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine.