11 51 030 Removing and installing/replacing component carrier: Notes
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- For additional information see: LIFTING THE VEHICLE USING A VEHICLE HOIST .
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
NOTE:
TECHNICAL INFORMATION
Notes for WORKING ON THE COOLING SYSTEM form the basis of these repair instructions and must be complied with at all times.
Notes for WORKING ON THE COOLING SYSTEM form the basis of these repair instructions and must be complied with at all times.
Preliminary work:
- Disconnect all battery ground leads
- Refer to REMOVING THE ACOUSTIC COVER
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CLEAN AIR PIPE
- Refer to REMOVING FAN COWL .
- Refer to REMOVING CHARGE AIR LINE
- Refer to REMOVING THE THROTTLE BODY
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION
- Refer to DRAINING THE COOLANT FROM THE HIGH-TEMPERATURE COOLING SYSTEM
- Refer to REMOVING THE ALTERNATOR
- Uninstall cover for the DME control unit
- Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Disconnect the connector from the DME control unit and from the power distribution module (PDM)
- Refer to REMOVING THE DME CONTROL UNIT
- Refer to REMOVING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to SUCTIONING AIR CONDITIONING SYSTEM (R134A) or SUCTIONING AIR CONDITIONING SYSTEM (R1234YF) .
- Refer to REMOVING CONDITIONING COMPRESSOR
Follow-up work:
- Refer to INSTALLING CONDITIONING COMPRESSOR
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to INSTALLING THE DME CONTROL UNIT
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Connect the connector to the DME control unit and the power distribution box (PDM)
- Install cover for the DME control unit
- Refer to INSTALLING THE ALTERNATOR
- Refer to INSTALLING THE THROTTLE BODY
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR
- Refer to INSTALLING CHARGE AIR LINE
- Refer to INSTALLING FAN COWL
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to CONNECT THE COOLANT HOSE TO THE RADIATOR
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
- Refer to INSTALLING ACOUSTIC COVER
- Connect all battery ground leads
- Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT SYSTEM
- Refer to FILLING AIR CONDITIONING SYSTEM (R134A) or FILLING AIR CONDITIONING SYSTEM (R1234YF) .
- Install the front underbody protection