11 23 010 Removing and installing/replacing vibration damper: Notes
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work:
- Disconnect all battery ground leads
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION
- Remove rear underbody protection
- Refer to REMOVING REINFORCEMENT PLATE
- Refer to REMOVING STARTER MOTOR
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CLEAN AIR PIPE
- Refer to REMOVING FAN COWL .
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR
Follow-up work:
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR
- Refer to INSTALLING FAN COWL
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to INSTALLING STARTER MOTOR
- Refer to INSTALLING REINFORCEMENT PLATE
- Install underbody protection at rear
- Install the front underbody protection
- Connect all battery ground leads