Installing the electric A/C compressor
- Install the electric A/C compressor (3).
- Tighten down screws (1) and (2).
TIGHTENING TORQUE SPECIFICATIONS
| Air conditioning compressor on crankcase | |
|---|---|
| M8 | |
| Replace screws. | |
| 20.5 Nm | |
- Position the holder (2) and tighten the bolt (1).
TIGHTENING TORQUE SPECIFICATIONS
| High-voltage line holder to air conditioning compressor | |
|---|---|
| Screw M6 | |
| 8 Nm | |
- Position the refrigerant line and tighten the bolt (3).
TIGHTENING TORQUE SPECIFICATIONS
| Refrigerant line on air conditioning compressor | |
|---|---|
| M8 | |
| Replace screw. | |
| 19 Nm | |
- Position the refrigerant line and tighten the bolt (2).
TIGHTENING TORQUE SPECIFICATIONS
| Refrigerant line on air conditioning compressor | |
|---|---|
| M8 | |
| Replace screw. | |
| 19 Nm | |
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALL ELECTRICAL HEATING .
- Refer to INSTALLING CONTROL UNIT HOLDER .
- Refer to INSTALLING BATTERY HOUSING (ENGINE COMPARTMENT) .
- Refer to INSTALLING AUXILIARY BATTERY (ENGINE COMPARTMENT) .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to FILLING THE AIR CONDITIONING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING THE COOLANT LINE TO THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE .
- Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT SYSTEM .