11 22 500 Removing and installing/replacing flywheel (N54, N54T)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Necessary preliminary tasks:
- Remove TRANSMISSION .
- Remove CLUTCH (except Automatic and DKG).
Enlarge special tool 11 9 260 with an elongated hole.
Enlarge elongated hole on special tool 11 9 260 to 8 mm.
For vehicles with manual gearboxes:
Secure flywheel with special tool 11 9 260 .
Release flywheel bolts with special tool 11 4 180 /
Tightening torque 11 22 2AZ .
Installation note:
The flywheel is secured with a dowel pin.
Fit new flywheel bolts.
For vehicles with automatic transmissions:
Secure flywheel with special tool 11 9 260 .
Release flywheel screws with a suitable tool (1).
Tightening torque 11 22 1AZ .
Installation note:
The flywheel is secured with a dowel pin.
Fit new flywheel bolts.
Assemble engine.