51 43 120 Removing and installing/replacing rear left or right side trim panel
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Necessary preliminary tasks:
- Remove REAR TOP SIDE TRIM PANEL
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Snap out speaker cover (1) with a suitable tool.
Lever out fixing rivet (2) from rubber skirt for inner window cavity cover strip.
Installation note:
If necessary, replace fixing rivet (2).
Partially remove door seal (4).
Lift off cover (2).
Remove storage net (3) with rod.
Release screw (1).
Installation note:
Make sure door seal (4) is correctly seated.
Lever out clips (1) with a suitable tool.
Release screw (2).
Tightening torque 72 11 03AZ .
Remove reversing clip (3).
Installation note:
Deflection fitting (3) is encoded against incorrect installation.
Remove side trim panel (1), as pictured, in direction of arrow.
Unlock and disconnect plug connection behind.
Installation note:
Make sure side trim panel (3) is correctly seated.
Retaining lugs (1) and (2) must not be damaged.
If necessary, replace side trim panel (3).
Replacement
Remount the MID-RANGE SPEAKER .