61 31 197 Removing and installing/renewing center console operating facility

Necessary preliminary tasks:

Version with manual gearbox only:

Version with automatic transmissions only:

IMPORTANT: Risk of damage!
Center console operating facility must not be pried out from the outside.

NOTE: Graphic shows example of F20 with automatic transmission.

Reach under front section of operating facility (1).
Press front latch mechanism in direction of arrow and simultaneously raise operating facility (1) towards top.
Disconnect associated plug connection and remove operating facility (1).

Fig 1: Removing Center Console Operating Unit
Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) must not be damaged or missing.

Make sure operating facility is correctly fitted in center console.

Fig 2: Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.

In case of replacement, remount operating unit cover:

Release latch mechanism (1) and remount cover (2), depending on equipment.

Fig 3: Operating Unit Cover And Latch Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) must not be damaged or missing.

Fig 4: Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.