11 65 180 Removing and installing/renewing heat shield at top (N63)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work:

Release screws (1).

Lift out holder.

Fig 1: Identifying Holder Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Tightening torque 11 65 3AZ .

Fig 2: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Tightening torque 11 65 3AZ .

Fig 3: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1).

Detach wire ring (2) and set down behind oxygen sensor.

Fig 4: Identifying Wire Ring And Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining clip (1).

Detach wire ring (2) and set down behind oxygen sensor.

Fig 5: Identifying Retaining Clip And Wire Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 11 65 3AZ .

NOTE: For purposes of clarity, the graphic shows the oxygen sensor removed.

Fig 6: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 11 65 3AZ .

Lift out heat shield.

Fig 7: Identifying Heat Shield Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.