11 12 006 Removing and installing/sealing right cylinder head cover (N63)
WARNING: This page is about a different variant/trim than selected.
Special tools required:
Necessary preliminary tasks:
- Remove ACOUSTIC COVER
- Disconnect NEGATIVE BATTERY TERMINAL
- Release battery positive terminal
- Drain COOLANT
- Remove right INTERCOOLER
- Remove INTAKE FILTER HOUSING
- Disconnect FUEL DELIVERY LINE
- Detach wiring harness for injectors and lay to one side
- Remove IGNITION COILS , cylinders 1-4
- Remove INJECTORS , cylinders 1-4
- Remove HIGH PRESSURE PUMP
Release screws (1).
Tightening torque 11 12 9AZ .
Remove oil filler neck (2).
Installation note:
Replace sealing ring.
Release bolts in sequence (17 to 1).
Remove cylinder head cover.
Clean sealing surface (1) with special tool 11 4 470 .
Installation note:
Replace seal (2).
Installation note:
Renew profile seal of cylinder head cover.
Installation note:
It is important to join screw (1) for exact positioning of the camshaft sensors.
Fit cylinder head cover.
Position screw (1).
Release screw (1) by 90°.
Secure cylinder head cover in sequence (1 to 17) in two work steps.
Tightening torque 11 12 3AZ .
Assemble engine.