54 10 155 Removing and installing/replacing rear floating headlining

Necessary preliminary tasks: 

• Remove FRONT FLOATING HEADLINING :

Move rear floating headlining (1) forwards (close).

Unfasten screws (2).

Tightening torque 54 10 03AZ .

Fig 1: Identifying Floating Headlining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Slide floating headlining (1) uniformly forwards.

If necessary, raise slider (2) for front and rear floating headlining.

Move slider (2) back to the point where there is no longer any contact to the floating headlining (1).

Fig 2: Raising Slider And Sliding Floating Headlining Forward

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rear floating headlining (1) as follows:

1. Press to the right in guide rail (2) of slider
2. Raise upward
3. Remove in direction of arrow
Fig 3: Removing Rear Floating Headlining
Courtesy of BMW OF NORTH AMERICA, INC.