24 00 055 Installing exchange gearbox (GA8HP70Z)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation
Drain automatic transmission fluid at oil drain plug.
Tightening torque 24 11 2AZ .
IMPORTANT:
After completion of work, program control transmission control unit.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations.
IMPORTANT:
- Before installing replacement transmission, always flush TRANSMISSION FLUID COOLER TOGETHER WITH LINES .
- After completion of repair work, CHECK TRANSMISSION OIL LEVEL .
- Use only approved TRANSMISSION OIL
.
Failure to comply with this requirement will result in serious damage to the automatic transmission
Exchange transmissions come filled with oil
Necessary preliminary tasks:
- Remove automatic transmission . See 24 00 034 Removing and installing automatic transmission (GA8HP70Z) N63 or 24 00 034 Removing and installing automatic transmission (GA8HP70Z) N63 AWD .
- Remount transmission mounting bracket . See 22 32 055 REMOVING AND INSTALLING/REPLACING GEARBOX BEARING BLOCK (N55, N57) or 22 32 055 REMOVING AND INSTALLING/REPLACING TRANSMISSION MOUNTING BRACKET AUTOMATIC .
Remount transportation retainer.
Remount all cable clips.
Remount all seal plugs.
Remount protective cap on output shaft.
IMPORTANT:
After removing transportation retainer, secure torque converter against slipping out.
Transmission identification:
- On type plate