17 21 500 Rinse transmission oil cooler with lines (GA8HP automatic transmission)
Special tools required:
Install a new or exchange transmission.
Procedure:
Automatic transmission removed.
Connect appropriate adapters (see description below) to oil lines exiting from automatic transmission.
Use quick-release coupling to connecting line 17 2 019 from oil dispenser unit.
Use quick-release coupling to drain line 17 2 018 .
Hold and direct open end of drain line into a suitable collecting vessel.
Using oil dispenser unit, flush approx. 1 liter of TRANSMISSION FLUID through oil lines and transmission oil cooler.
Reposition quick-release couplings.
Flush oil lines/transmission oil cooler in opposite direction with approx. 1 liter of TRANSMISSION FLUID .
Disconnect quick-release couplings.
Remove adapter.
Recycling:
Never use flushing oil.
Dispose of flushing oil according to country-specific waste disposal regulations.
Press hydraulic lines (1) into adapters (2).
Slide clamping bracket (3) into guides and secure with screw (4).
Arrangement of flushing device:
Special tools required:
Installing a new or exchange transmission.
Flushing can only be carried out when the automatic transmission is removed.
Procedure:
Automatic transmission removed.
Connect appropriate adapters (see description below) to oil lines exiting from automatic transmission.
Use quick-release coupling to connecting line 17 2 019 from oil dispenser unit.
Use quick-release coupling to connect drain line 17 2 018 .
Hold and direct open end of drain line into a suitable collecting vessel.
Using oil dispenser unit, flush approx. 1 liter of TRANSMISSION FLUID through oil lines and transmission oil cooler.
Reposition quick-release coupling.
Flush oil lines/transmission oil cooler in opposite direction with approx. 1 liter of TRANSMISSION FLUID .
Disconnect quick-release coupling.
Remove adapter.
Do not reuse under any circumstances.