63 11 845 Replacing left LED fan (inner)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

2 296 785

Necessary preliminary tasks:

Remove HEADLIGHT WITH LED TECHNOLOGY
Remove HEADLIGHT DRIVER MODULE

Release latch mechanism (1) and screws underneath.

Tightening torque 63 11 6AZ .

Remove cover (2).

Fig 1: Identifying Cover And Latch Mechanism

G10064409

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Gasket (1) must not be damaged and must be installed free from grease.

Fig 2: Identifying Gasket

G10064410

Courtesy of BMW OF NORTH AMERICA, INC.

Press together connector (1) (arrow) and disengage to the rear into light housing.

IMPORTANT: Risk of damage.
Do not bend pins of connector (1).

Fig 3: Unlocking Connector

G10064411

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2) on LED fan through opening (1). Release screw (3) through opening (1) with special tool 2 296 785 .

Screw (2; 3) tightening torque 63 11 5AZ .

Fig 4: Releasing Screws Using Special Tool

G10064412

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Remove fan (2) to the side.

Fig 5: Removing Fan

G10064413

Courtesy of BMW OF NORTH AMERICA, INC.