63 12 140 Remove and install left LED technology headlight
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove FRONT BUMPER PANEL
WARNING:
Follow notes for HANDLING BULBS/LIGHT SOURCES (EXTERIOR LIGHTS) .
Lever out expanding rivets (1) on engine compartment lid seal (2).
Remove seal for engine compartment lid (2) on left.
Release screws (1) on headlight (3) at top.
Tightening torque 63 12 1AZ .
Release screws (1) on headlight (2) at bottom.
Tightening torque 63 12 1AZ .
Pull out headlight (1) in direction of arrow slightly.
Disconnect plug connection (1) on headlight (2) and remove headlight.
Installation note:
Adjust HEADLIGHT .