63 11 820 Replacing left cornering light LED module (From 04/2015)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1).

Tightening torque 63 11 3AZ .

Remove LED module (2).

Fig 1: Identifying LED Module Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable tie (1).

Disconnect connector (2).

Remove LED module (3).

Installation note:

Replace cable tie (1).

IMPORTANT: Risk of damage due to moisture penetration.
Gasket (4) on LED module (3) must not be damaged or missing.

Fig 2: Identifying LED Module Connector, Cable Tie, And Gasket

Courtesy of BMW OF NORTH AMERICA, INC.