33 32 153 Removing and installing/replacing front compression strut

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Driving without compression struts is not permitted!

Necessary preliminary tasks:

Release screws of underbody panelling (1).

Remove underbody panelling (1).

Fig 1: Locating Underbody Panelling Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 33 33 2AZ .

Release screw (2) and remove compression strut (3).

Tightening torque 33 33 1AZ .

IMPORTANT: Secure rear axle support by inserting screw (2).

Installation note:

Check threads for damage; if necessary, repair with HELI-COIL THREAD INSERTS .

Fig 2: Identifying Compression Strut Screw

Courtesy of BMW OF NORTH AMERICA, INC.