33 32 051 Removing and installing/replacing left or right anti-roll bar link/integral link
WARNING: This page is about a different variant/trim than selected.
NOTE:
If the integral link is detached from the swinging arm, it is necessary after installation to carry out a chassis/wheel alignment check.
Necessary preliminary work:
- Remove REAR WHEEL .
Release nut (1) and remove screw.
Tightening torque 33 32 4AZ .
Release screw (2) and remove integral link (3).
Tightening torque 33 32 5AZ .
Installation note:
Replace screw and nut.
Tighten screw connections in NORMAL POSITION .
After installation:
- Perform chassis/wheel alignment check . See 32 00 150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 32 00 155 KDS WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD