33 34 060 Removing and installing/replacing control unit for rear axle slip control

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Unlock plug connection (1) on control unit (2) and disconnect.

Fig 1: Identifying Control Unit Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove control unit (2).

Tightening torque 33 34 5AZ .

Fig 2: Identifying Control Unit Nut

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: