66 53 060 Removing and installing/renewing the Top View camera

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Unfasten plug connection (1) and disconnect.

Unfasten screws (2).

Remove exterior mirror camera.

Fig 1: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Use of a special tool is no longer required.

Calibration:

Calibration is performed via BMW diagnosis system:
- Service function
- Body
- All-round vision camera
- Calibration of all-round vision camera