65 13 080 Removing and installing/replacing speaker (tweeter in rear side trim panel)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Disconnect plug connection (1).

Remove resistor (2) from holder.

Release screws (4).

Tightening torque 65 13 4AZ .

Remove speaker (3) from door trim panel.

Installation note:

To tighten screws, use special tool 00 9 460 .

Speaker (3) is encoded to prevent incorrect installation.

Fig 1: Identifying Speaker, Plug Connection, Resistor, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.