51 43 002 Removing and installing rear left or right side trim panel

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screw (1).

Unclip side trim panel (2) at marked points.

Unlock associated plug connections and cable clip and disconnect.

Remove side trim panel (2).

Installation note:

Make sure edge protection (3) on side trim panel is correctly seated.

Fig 1: Identifying Edge Protection, Side Trim Panel, And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Fit all clips (1) with sealing ring.

If necessary, replace faulty clips (1).

IMPORTANT: Different types of clips are used.
Note color coding.

Fig 2: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.