12 14 513 Replacing pulse generator on right exhaust camshaft (N63)

WARNING: This page is about a different variant/trim than selected.

(cylinder bank 1 to 4)

Necessary preliminary tasks:

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
Remove right INTAKE FILTER HOUSING

Unlock plug (1) and remove.

Release screw (2).

Tightening torque 13 62 3AZ .

Remove pulse generator (3).

Fig 1: Identifying Pulse Generator, Plug And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring and coat with antiseize agent.

NOTE: Now clear the fault memory.