64 11 902 Replacing interior temperature sensor blower (A/C control panel)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

Necessary preliminary tasks:

Release screws (1).

Tightening torque 61 31 2AZ .

NOTE: Use special tool 00 9 450 to tighten screws.

Remove fan (2) from IHKA controls (3).

Installation note:

Make sure pins (4) are correctly located on fan (2).

Fig 1: Identifying Fan Screws From IHKA Controls

Courtesy of BMW OF NORTH AMERICA, INC.