61 31 321 Removing and installing radio and A/C control panel

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Risk of damage.

A hard disk is installed in the Car Information Computer (CIC).

Carry out mechanical work on the CIC and adjacent components with care.

Avoid subjecting the CIC to vibration/shocks.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

IMPORTANT: Carry out installation in a dust-free workshop area only.
To avoid damage, do not touch or dirty the display field.

Necessary preliminary tasks:

Disengage the cover (2) below the radio and AC control panel (1) toward the front.

Fig 1: Identifying Control Panel And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining tabs on the cover (1) must not be damaged.

If necessary, replace cover (1).

Fig 2: Locating Retaining Tabs

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove radio and IHKA controls (2).

Unlock plug connections behind and disconnect.

IMPORTANT: Assign keypad depending on optional equipment .

Fig 3: Identifying Radio/IHKA Controls And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: