64 11 879 Replace control panel for heater/air conditioning system
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION)
.
IMPORTANT:
Retrofitting must only be done in the supplied installation cassettes.
Use of supplied gloves is mandatory.
Carry out installation in a dust-free workshop area only.
To avoid damage, do not touch or contaminate the display area.
Use of supplied gloves is mandatory.
Carry out installation in a dust-free workshop area only.
To avoid damage, do not touch or contaminate the display area.
Necessary preliminary work:
- Remove RADIO AND IHKA CONTROLS
Disconnect plug connection (1).
Release short screw.
Tightening torque 61 31 2AZ .
Release long screws (2).
Tightening torque 61 31 2AZ .
Carefully unlock clamps (3).
Pull up and remove IHKA controls (4).
Installation note:
Assign buttons of IHKA controls depending on equipment.
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .