66 53 020 Removing and installing (replacing) reversing camera
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Remove BUTTON FOR TAILGATE ACTIVATION .
Unclip rear view camera (1) left and right and feed out of button holders (2).
Unlock associated plug connection and disconnect.
Installation note:
Seal (3) of rear view camera (1) must not be damaged and must be installed.
Insert rear view camera (2) as shown in button holder (1).
Engage rear view camera (2) in direction of arrow in button holder (1).
Latch mechanisms (3) must not be damaged.
Installation note:
Make sure the rear view camera is latched correctly (2)!
After installation:
- Calibrate REVERSING CAMERA .
Replacement:
Carry out VEHICLE PROGRAMMING/CODING .