51 24 147 Replace button for tailgate activation

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 327

Attention!

Disassembly of the button is not possible without destroying it.

To avoid water ingress, the button must be replaced every time after disassembly.

Place special tool 00 9 327 at areas (A) between tailgate and button (1).

Destroy retaining tabs (2) in areas (A) by striking special tool 00 9 327 .

Pull out button (1) from latch mechanisms (2) in area (B).

Disconnect associated plug connections and remove button (1).

Installation note:

Check tailgate for damage, touch up if required.

Fig 1: Installing Special Tool (00 9 327)

Courtesy of BMW OF NORTH AMERICA, INC.

Perform function check with tailgate open.

Version with reversing camera:

Unclip rear view camera (1) left and right and feed out of button holders (2).

Installation note:

Seal (3) of rear view camera (1) must not be damaged and must be installed.

Fig 2: Locating Rear View Camera Seal

Courtesy of BMW OF NORTH AMERICA, INC.