28 60 030 Removing and installing/replacing the hydraulic cap (GS7D36SG)
WARNING: This page is about a different car, the 2016 BMW M5, 2015 BMW M5, 2014 BMW M5, and 2013 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
It is essential to adhere to conditions of absolute cleanliness.
Any dirty parts must be cleaned before the hydraulic cap is loosened.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Any dirty parts must be cleaned before the hydraulic cap is loosened.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Remove TWIN-CLUTCH GEARBOX
Place twin clutch transmission on a suitable surface.
To prevent the transmission oil from spilling out, make sure that the hydraulic cap points upward.
Release screws.
Remove hydraulic cover (1).
Installation note:
Replace gasket.
Replace screws.
Installation of hydraulic cap: Make sure seal is exactly seated.
It is mandatory to comply with the specified order of screw connections 1-12.
Tightening torque: 10 Nm