28 00... Checking/topping up oil level in twin-clutch gearbox (GS7D36SG)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Checking oil level:
- Call up Service functions (Drive) in BMW diagnosis system
- Carry out oil level check in accordance with instructions
IMPORTANT:
On the twin-clutch gearbox a run-in check fluid change is not
required at 2000 km.
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
Use only the approved TRANSMISSION OIL .
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.
IMPORTANT:
The testing and filling procedure must
be completed before the transmission oil temperature of 40 °C is reached.
If a temperature in excess of 40 °C is reached and no oil has emerged, insert the fluid adjusting screw and repeat the testing and filling procedure when it has cooled down.
If a temperature in excess of 40 °C is reached and no oil has emerged, insert the fluid adjusting screw and repeat the testing and filling procedure when it has cooled down.
Installation note:
Tighten down oil filler plug using
- Hexagon wrench 8 A/F
- Torque wrench
- Socket 8 A/F
Topping up transmission oil after a repair:
Stand vehicle on a level surface and secure against rolling off.
- Open fluid adjusting screw (1). If fluid emerges, close screw again immediately
If no fluid emerges, top up until fluid emerges and close fluid adjusting screw (1) again
NOTE: If fluid has been replenished here, a further refill must be carried out during the actual fluid adjustment - Connect diagnosis system and start service functions (drive).
- Start engine (drive position N or P)
- Record transmission temperature using the diagnosis system
- (Drive position P)
- Permissible starting temperature ≤ 32 °C
- Idle speed: maintain at approx. 2000 RPM for 1 minute.
- Open fluid adjusting screw (1)
- Fill until oil emerges
Max. transmission oil temperature 40 °C
- Insert screw
Installation note:
Replace screw.
Tightening torque: 25±3 Nm