24 34 026 Replacing Sealing Sleeve For Transmission Housing (GA8P70H) N55_Hybrid

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

24 2 390

IMPORTANT:

Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
Wear protective gloves.
Ensure adequate ventilation.

IMPORTANT: After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary work:

Disconnect NEGATIVE BATTERY LEAD .
Remove rear UNDERBODY PROTECTION .
Remove TRANSMISSION OIL SUMP .
Remove OIL PUMP (IEP) .

IMPORTANT: Support transmission with workshop jack.

Unlock and disconnect connector (1) by turning.

Fig 1: Disconnecting Automatic Transmission Connector

G09848209

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 2: Inserting Special Tool (24 2 390) In Sealing Sleeve

G09848385

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and unlock sealing cup with slide (2).

Tightening torque: 24 30 4AZ .

Fig 3: Sealing Cup And Screw

G08488059

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Make a note of installation position of sealing sleeve.

Pull out sealing cup (1).

Installation note:

Fit sealing sleeve in position (lug on inner surface). Turn until lug engages in groove of transmission. Slide in sealing cup.

Lug on sealing sleeve must not be damaged!

Fig 4: Pulling Sealing Cup

G09848440

Courtesy of BMW OF NORTH AMERICA, INC.