61 31 357 Removing and installing (renewing) gear selector switch (M5 with twin-clutch gearbox)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

Necessary preliminary tasks:

Remove CENTER CONSOLE COVER

Release screws (1).

Tightening torque 61 31 1AZ .

Installation note:

Insert gear selector switch (2) correctly in front and rear fixation of center console support (3).

Fig 1: Locating Gear Selector Switch And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Raise the gear selector switch (1).

Unlock and disconnect plug connection (2) at gear selector switch (1).

Fig 2: Identifying Gear Selector Switch

Courtesy of BMW OF NORTH AMERICA, INC.