22 32 001 Replacing rubber mount for transmission mounting (ATC 350)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Necessary preliminary tasks
- Remove complete exhaust system . See 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N55) or 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N63) .
- Remove transmission cross member . See 22 32 050 REPLACING THE CROSS MEMBER FOR THE TRANSMISSION MOUNTING (N20, N55, N47) ALL-WHEEL DRIVE VEHICLE or 22 32 050 REPLACING CROSS-MEMBER FOR TRANSMISSION MOUNTING (N63) AWD .
For better illustration: Front propeller shaft is removed.
IMPORTANT:
For: F01, F07, F10, F11, F12, F13 - N57 and N55 a gearbox mount is located on the left side of the transmission below the front propeller shaft.
Undo bolts (1) for gearbox mount.
Tightening torque 22 32 10AZ .
Undo bolts (1) for gearbox mount.
Tightening torque 22 32 10AZ .
Necessary preliminary tasks
Lower transmission with hydraulic lifting equipment.
Mount special tools 22 1 042 /22 1 041 on transfer box.
Pull out rubber mount with thrust plate 22 1 043 by means of spindle 33 4 460 and nut 22 1 017.
Installation note:
Pay attention to installation position of rubber mount (1).
Bolt special tool 22 1 044 to transfer box.
Insert special tool 22 1 046 with bolt into recesses of rubber mount.
Draw in rubber mount with special tool 33 4 460.
Installation note:
Auxiliary installation material - low-surface-tension water.
Do not coat rubber mount with grease.