12 61 280 Removing and installing/replacing oil pressure sensor (N55)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Turn off ignition
- Remove IGNITION COIL COVER
WARNING:
Risk of burning!
Only perform this task on an engine that has cooled down.
Only perform this task on an engine that has cooled down.
Installation location
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock plug (1) and remove.
Release oil pressure sensor (2).
Tightening torque 12 61 1AZ .
NOTE:
Add final details to vehicle
Check engine oil level. Top up engine oil if necessary.
Check engine oil level. Top up engine oil if necessary.